Zenith-data-systems MT2000 Manuale Utente Scaricare il pdf (Pagina 133)

5-45

Upgrades and Options

Figure 5-19. Removing Side Rails

Removing side rails from

blank panel tray

A Screws

B Side rails

C Blank panel tray

11.

Remove the device from its protective wrapper and

place it on an antistatic surface. Record the drive

model and serial number in the equipment log.

12.

Set any device jumpers or switches on the device.

Refer to the installation procedures that came with

the device.

Notice: SCSI termination resistors for the 5 1/4-inch

devices must be installed in the last SCSI device of the

daisy chain cabling (top media bay A). All other 5 1/4-

inch devices must have terminators removed.

13.

Using the four screws supplied with the drive,

reinstall the side rails just removed from the blank

panel tray (Figure 5-20, A). Attach the rails to each

side of the device (C) by using only the bottom screw

holes, as shown. The rails for each side of the device

are identical.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 204 205

Nessun commento

Zenith-data-systems MT2000 Manuale Utente Pagina 133